[Pole Shaft]
|
[Anchor Bolts]
Anchor bolts are fabricated from commercial quality hot rolled carbon steel bar that meets or exceeds a minimum yield strength of 55,000 psi. Four properly sized anchor bolts, each with two regular hex nuts and washers, are furnished and shipped with all poles unless otherwise specified. Anchor bolts shall have the threaded end galvanized a minimum of 8 inches in accordance with ASTM A-153.
Fully galvanized anchor bolts are available upon request.
|
[Base Plate]
|
[Handhole]
|
[Finish]
All exterior metal surfaces are mechanically cleaned to remove all oxides and contaminants prior to coating. The standard finish is a polyester thermosetting powder coating applied to the surface of the substrate to a minimum of 3 mils for all color finishes.
Galvanizing is available upon request.
|
|
FINISH
| P - Primer | BK - Black Finish Color | BZ - Bronze Finish Color | GN - Green Finish Color | GY - Gray Finish Color | LA - Dark Natural Aluminum | LM - Natural Aluminum | G - Hot Dipped Galvanized | WH - White Finish Color | CT - Custom Color | G/BK - Black over Galvanized | G/BZ - Bronze over Galvanized | G/GN - Green over Galvanized | G/GY - Gray over Galvanized | G/LM - Natural Aluminum over galvanized | G/WH - White over Galvanized | G/CT - Custom over Galvanized |
MOUNTING DESIGNATIONS
| OT - Open Top | PC - Pole Cap | 2 - 2 3/8” OD Tenon | 3 - 2 7/8” OD Tenon | 3.5 - 3 1/2” OD Tenon | 4 - 4” OD x 6” Tenon | DM - Drilled Mount | DM10 - Drilled for 1 Luminaire | DM29 - Drilled for 2 Luminaires at 90º | DM28 - Drilled for 2 Luminaires at 180º | DM39 - Drilled for 3 Luminaires at 90º | DM49 - Drilled for 4 Luminaires at 90º | WP - Wood Pole |
* Standard location for DM10 is 90º to the right of the handhole.
OPTIONS
| XHH - Extra Handhole | WPRP - Festoon Opening | CPL - Threaded Coupling | NPL - Threaded Nipple | VDI - Vibration Damper Internal | BC - Base Cover | NC - Nut Covers | LAB - Less Anchor Bolt | EMB - Embedded Pole |
|